The Redding Chamfer and Deburring Tool removes burrs and bevels case mouths for easy bullet seating. The hardened precision ground flutes make clean, easy, chatter-free cuts and works with all cases from 17 to 45 caliber.
More info Click here
MTM CASE-GARD rifle ammunition cases are still the first choice of rifle enthusiasts throughout the world. Made of virtually indestructible polypropylene that will not warp, crack, chip, peel, expand or contract. This box also features are mechanical hinge which is guaranteed for 1 million open-close cycles or 25 years. Snap-Lock latch protects contents from accidental spilling. Each CASE-GARD 100 ammo box is supplied with a load label for recording load data. This style of CASE-GARD 100’s is available in two sizes. All rounds listed bullet up.
Designed for the sportsmen on the move, the SPUD6 features loads of storage room along with molded-in bungee hook receiver so you can strap it down tight to anything, from a fishing boat to an ATV.
The SPUD 7’s spacious design offers a whopping 2,073 cubic inches of dry storage. It can carry items up to 14 inches tall. It is also the perfect height (15 inches) for dove and waterfowl blind hunting and as a chair when using MTM’s predator shooting table. It also comes with a nylon shoulder strap for hands free carrying. Load one up for the range and then use it for a chair once you get there!
Both the SPUD6 & 7 offers several features including: Water resistant O-ring seal; top access lid compartment ; deep 2/3 length lift out tray; four Bungee hook receivers; large comfortable handle; thick sidewall construction; heavy-duty snapping latches; and double padlock tabs.
Worn on the belt, this CASE-GARD ammo carrier puts twenty rounds at the hunter’s fingertips. Each cartridge fits into its own recess, bullet down for easy removal. Two special ribs protect the bullet from touching the bottom of the case to guard against tip damage (which can change the flight characteristics of a bullet). Not only will your ammo be protected from dust and moisture, but the MTM Snap-Lok latch will prevent accidental openings. The calibers listed below will provide bullet tip protection with very little rattle; however, calibers not listed will fit loosely.
The Model #1400-XT Case Trimming Lathe uses a cast iron frame that has been extended to handle all the latest long action cartridges. The frame is cast iron because it is a perfect bearing surface, will not wear out and will maintain its precision and alignment for years of service.
More info Click here
MTM RIFLE AMMO BOX(RM-50-10) FLIP TOP 
MTM RIFLE AMMO BOX(RM-20-10) 
REDDING THE CLASSIC MODEL 3 POWDER MEASURE(03000) 
